Harmonic Filter

HARMONIC FILTER

REDUCTION IN KILOWATT HOUR CONSUMPTION FROM 9-39% Even higher depending on the (business usage model)

Sanrgy’s Low Pass Harmonic Filter, , allows facilities to reduce energy consumption and cost. Our Low Pass Harmonic Filter is an inductive device that reduces daily KWhr consumption, Harmonics and Electricity Demand in commercial facilities by performing two functions

1.       It removes “noise” (that results from incoming voltage leg being out of balance) or harmonic distortion from the broad band spectrum of harmonics, including 3^rd, 5^th, 7^th, 9^th and 11^thharmonics.
2.       The inductive qualities provide a restoration of phase and polarity to the electrical circuit.
3.       It reduces Line Loss.

Our Low Pass Harmonic Filter is a unique patented technology that uses fundamental electromagnetic principles to reduce energy consumption economically. The new electricity load profile exacerbates non-efficient use of electricity. Electrical current out of phase and polarity, referred to as “noise” or “harmonic distortion” is an undesirable by-product of the electrical grid and the new electricity load profile.
Today’s electronic and electrical equipment by design see power in proper phase and polarity and draw on the electrical system continuously to meet this function. Our Low Pass Harmonic Filter addresses this issue like no other products do.
As an Energy Management Device, our Low Pass Harmonic Filter reduces daily Kwhr consumption by inductively capturing noise on the neutral lines. Savings vary depending on the electrical profile of the facility’s load.

Quick Facts:
· REDUCTION In daily KILOWATT HOUR (kwhr) consumption ranges from an Amazing ( 5-32% )

· Return on Investment is usually less than 4 months (90% of customers reported)

· Easy installation without interrupting your business operation

· Performance verified and certified by an independent laboratory

· Safety certified by Met Laboratories to comply with UL

· Maintenance free solid-state unit

· One year Manufacturers Product Warranty

For more information on Sanrgy’s Harmonic Filter CONTACT US

Hi Patrick, We did our first meter reading since the Line Loss Pro was installed. We are very consistent on the power we use as we are a 24/7/362 business. Motors always run and the lights are on. We are always looking for ways to cut energy costs. On the 208 volt meter prior to the install we used 26,700 kWh for a 7 day test period. After install 4/15/2015 of the LLG’s we used 19,800 kWh’s for the same amount of time. That is a difference of 25.8 % in consumption of power. For the same period last year 4/15/2014 we used 27,000kWh’s as the week after installation. On the 480 volt side we did a test run prior 7 days we used 9920kWh’s and after install4/15/2015 our big chillers ran for 3 days. So the after install meter reading was 10,000 kWh’s. Even though the chillers ran and we had an increase in usage it would be fair to say that there was a savings on the 480 Volt also of roughly 20+%. As time goes on we will be able to compare with readings form the same periods as last year when the chiller runs during the summer months. I will keep in touch and let you know how we do. I would like to thank you for reaching out to us here at Murray County Medical Center in Slayton and helping us to save energy in our business. Arl Weinrebe Murray County Medical Center Director of Plant Operations 2042 Juniper Ave Slayton MN 56172

Arl Weinrebe Murray County Minn Med Ctr Director Plant Operations